---
title: "MA Lighting grandMA2"
url: "https://showcaller.ai/integrations/ma-lighting-grandma2/"
type: "integration"
published: "2026-06-17T19:35:00+00:00"
modified: "2026-11-06T19:33:05+00:00"
author: "admin"
---

Showcaller AI gives you grandMA2 remote control from the same conversation as the rest of the show. It connects to a grandMA2 console or grandMA2 onPC over the network. Then it fires what the lighting operator would, by voice or chat. For example, it can Go on sequence 1, jump to cue 12 or step back a cue. It can also pause a sequence or push executor 5 on page 2 to 80 percent. Switching to page 3 or running macro 20 works the same way.

Showcaller logs in to the console with the user account you give it, through the Bridge App on your show network. It reads the console’s reply to every command. So when the console refuses a command, Showcaller reports a failure, not a success. It also reads which executor page is active, so it confirms a page change. However, the console does not report playback state in a form Showcaller can read yet. So Showcaller reports a Go or a fader move as accepted by the console. It does not check it against the stage.

For anything the playback functions do not cover, you can use the command line. Showcaller types the command exactly as you would. Command-line use, macros and turning sequences or executors off all need your confirmation first.

Showcaller supports the grandMA2 full-size, grandMA2 light and grandMA2 onPC on software 3.x. MA Lighting describes the range on its [grandMA2 page](https://www.malighting.com/grandma2/). For the newer consoles, see the [MA Lighting grandMA3 integration](/integrations/ma-lighting-grandma3/).

## Questions about grandMA2 remote control

### Which grandMA2 consoles are supported?

Showcaller supports grandMA2 full-size, grandMA2 light and grandMA2 onPC. They must run grandMA2 software 3.x.

### What do I need to connect it?

You need the IP address of the console or onPC computer. You also need a console login. By default, that is the “administrator” user with no password. Then run the Showcaller Bridge App on a computer on the same network. On the console, switch “Login Enabled” on. Also allow Telnet access for the computer that runs the Bridge App.

### Which plan includes which Tool Functions?

Starter includes Device Diagnostics, Sequence & Cue Playback and Macro Triggers (7 Tool Functions). Pro adds Executor Control and Page Management (5 more). Enterprise then adds the Raw Command Line (1 more). Each plan includes every Tool Function of the plans below it.

### Does Showcaller confirm that a cue actually ran?

It confirms that the console accepted the command, and it reports any refusal. However, it does not yet read playback state back from the console. So it cannot confirm what is on stage. Page changes are the exception, because Showcaller reads them back.
