---
title: "MA Lighting grandMA3"
url: "https://showcaller.ai/integrations/ma-lighting-grandma3/"
type: "integration"
published: "2026-06-17T19:35:35+00:00"
modified: "2026-11-06T19:33:05+00:00"
author: "admin"
---

Showcaller AI gives you grandMA3 remote control by voice or chat. So you can fire grandMA3 playback from the same conversation as the rest of the show. Showcaller sends commands to a grandMA3 console or grandMA3 onPC over the network. For example, it can Go on a sequence, jump to a cue, or step forward or back. It can also pause or turn off a sequence, and press Go or Off on an executor. In addition, it can move an executor’s master fader, switch executor pages or run a macro.

Showcaller sends these commands through the Bridge App on your show network, using the console’s OSC input. However, OSC on the grandMA3 is one-way, because the console does not answer. So Showcaller can confirm that it sent a command, but not that the console acted on it. It says so when it reports back, instead of claiming a cue ran. Showcaller does not read any grandMA3 change back from the console. Keep an eye on the console or the stage for confirmation, as you would with any one-way remote.

For anything the playback functions do not cover, you can use the command line. Showcaller types the command exactly as you would on the console. Command-line use, macros and turning sequences or executors off all need your confirmation first.

Showcaller supports grandMA3 full-size, grandMA3 light and grandMA3 onPC on software 2.x. You can read about the range on [MA Lighting’s grandMA3 page](https://www.malighting.com/grandma3/). For older consoles, see the [MA Lighting grandMA2 integration](/integrations/ma-lighting-grandma2/).

## Questions about grandMA3 remote control

### Which grandMA3 consoles are supported?

Showcaller supports grandMA3 full-size, grandMA3 light and grandMA3 onPC. They must run grandMA3 software 2.x.

### What do I need to set up on the console?

First, open Menu > In & Out > OSC on the console. Enable an OSC data line for input and switch “Receive Command” on. Leave the OSC prefix empty. Then give Showcaller the console’s IP address and that line’s port, which is 8000 by default. Finally, run the Showcaller Bridge App on a computer on the same network.

### Which plan includes which Tool Functions?

Starter includes Device Diagnostics, Sequence & Cue Playback and Macro Triggers (7 Tool Functions). Pro adds Executor Control and Page Management (4 more). Enterprise then adds the Raw Command Line (1 more). Each plan includes every Tool Function of the plans below it.

### Does Showcaller confirm that a cue ran?

No. The grandMA3 does not reply to OSC commands. So Showcaller confirms that it sent the command, not that the console acted on it. This is different from most Showcaller integrations, where Showcaller reads changes back from the device.
