---
title: "QLab (Figure 53)"
url: "https://showcaller.ai/integrations/qlab-figure-53/"
type: "integration"
published: "2026-06-19T14:08:43+00:00"
modified: "2026-11-06T19:33:05+00:00"
author: "admin"
---

Call the show and let Showcaller AI press GO. Showcaller connects to [QLab from Figure 53](https://qlab.app/) on the show Mac and runs the cue stack by voice or chat. For example, it can GO, hold and resume, or jump the playhead to cue 42. It can also fire the walk-in music out of order or stop one cue. When something goes wrong, it can panic the whole workspace.

Showcaller reaches QLab over your local network through the Bridge App, using QLab’s own OSC control. Beyond playback, it can read and change what is in the workspace. That includes cue names, numbers and colors. It also includes notes, flags and targets. Then there are pre-waits, post-waits, durations and continue modes. In addition, Showcaller can create, move, renumber and delete cues.

On Audio cues, it sets levels and routing. It also sets rate, loops and trims. Showcaller writes and restyles Text cues mid-show. For lighting, it edits Light cue levels and drives the Light Dashboard. Then it places Video cues on surfaces and layers. It also works QLab’s audio patches and spatial Audio Maps. Finally, it switches QLab’s global input and output overrides. These cover DMX, MIDI, MSC, network and timecode.

Showcaller reads most changes back from QLab before it reports them done. It can also tell you whether a cue is loaded, running, paused or broken. However, it asks you first before stops, panics and deletions. The same goes for renumbering, saving the workspace and output overrides.

Showcaller supports QLab 5 and QLab 4. A few functions depend on the version. Spatial Audio Maps and some Light Dashboard actions need QLab 5, while video effect settings are QLab 4 only.

## Questions about QLab (Figure 53) control

### Which versions of QLab are supported?

Showcaller supports QLab 5 and QLab 4. Spatial Audio Maps and some Light Dashboard actions are QLab 5 only. On the other hand, video effect settings are QLab 4 only.

### What do I need to set up in QLab?

In Workspace Settings > OSC, turn on “Use OSC controls”. Showcaller then needs the IP address of the Mac running QLab. It also needs the OSC port if it is not 53000, and the passcode if the workspace has one. You need the Showcaller Bridge App on a computer on the same network too. When the Mac has several workspaces open, you can pick one. Otherwise, Showcaller works with the frontmost workspace.

### Which plan includes which Tool Functions?

Starter includes Connection & Diagnostics, Playback Transport, Playhead & Selection, and Cue Actions (43 Tool Functions). Pro adds Cue Properties, Cue Timing & State, and Cue List Management. It also adds Audio Cue Control and Workspace Management (59 more in Pro). Enterprise adds Fade Cue Design, Video & Geometry, Text Cues, and Light Cues & Dashboard. It also adds Audio Patch & Spatial Maps and System Overrides (59 more in Enterprise). Each plan includes every Tool Function of the plans below it. See [pricing](/pricing/) for the plans.

### Will Showcaller stop or delete cues without asking?

No. Showcaller asks for your confirmation first before stops and panics. The same goes for deleting or renumbering cues, saving the workspace and changing output overrides.
