---
title: "Shure Wireless"
url: "https://showcaller.ai/integrations/shure-wireless/"
type: "integration"
published: "2026-03-12T20:30:11+00:00"
modified: "2026-11-06T19:33:05+00:00"
author: "admin"
---

Shure wireless monitoring with Showcaller AI tells you the state of every mic before it becomes a problem. It connects to Shure ULX-D, QLX-D and SLX-D receivers over your local network. Then it answers the questions an A2 asks all show long, by voice or chat. For example, how many minutes are left on the lectern pack? What gain is channel 2 at, and what frequency is channel 3 on?

Showcaller connects to each receiver through the Bridge App on your show network. In one request, it reads the full status of every channel on a receiver. For each channel, it shows the transmitter’s battery as bars and the estimated runtime in minutes. On ULX-D and QLX-D, it also reads the charge percentage and battery health of Shure rechargeables.

Showcaller can also set output gain from -18 to +42 dB in 1 dB steps and name channels. On ULX-D, it can mute and unmute a receiver’s audio output without dropping the RF link to the performer.

For frequency work, Showcaller reads each channel’s operating frequency and its Group and Channel assignment. It can then move a channel to a new frequency or Group/Channel, using Shure’s own coordinated frequency sets. However, it confirms frequency changes with you first. Showcaller reads most changes back from the receiver before it reports them done.

To find a unit in a rack of identical receivers, Showcaller can flash its front-panel lights. This works on ULX-D and SLX-D, but not on QLX-D. Showcaller supports the ULXD4, [ULXD4D](/integrations/shure-wireless/shure-ulxd4d/) and ULXD4Q, the QLXD4, and the SLXD4 and SLXD4D. Shure lists the hardware details on its [ULX-D product page](https://www.shure.com/en-US/products/wireless-systems/ulx-d_digital_wireless).

## Questions about Shure wireless monitoring

### Which Shure receivers are supported?

Showcaller supports ULX-D (ULXD4, ULXD4D dual and ULXD4Q quad) and QLX-D (QLXD4). It also supports SLX-D (SLXD4 and SLXD4D dual).

### What do I need to connect a receiver?

You need the receiver’s IP address. It shows on the front panel under the Network menu. You also need the Showcaller Bridge App on a computer on the same network. Receivers accept control connections on port 2202 without a password. However, on newer firmware some models need third-party network control switched on. You can do that in Wireless Workbench or in the receiver’s web interface.

### Which plan includes which Tool Functions?

Starter includes Device Diagnostics, Mute Control and Battery Monitoring. Pro adds Audio Gain Control and Channel Naming. Enterprise then adds Frequency Management and Device Identify (flash). Each plan includes every Tool Function of the plans below it.

### Can Showcaller mute a QLX-D or SLX-D channel?

No. QLX-D and SLX-D receivers have no remote audio mute, so mute control works on ULX-D only. Also, SLX-D does not report battery charge and health percentages. Battery bars and runtime still work on SLX-D.

### Can Showcaller lock a transmitter’s buttons?

No. Shure receivers do not offer a transmitter lock command over the network. So Showcaller cannot lock or unlock bodypacks or handhelds.

### Can it run an RF scan?

No. Shure wireless monitoring in Showcaller covers frequencies and Group/Channel assignments. However, Showcaller does not scan the RF spectrum.
